Effect of cerium oxide prepared under different hydrothermal time on electrocatalytic performance of Pt-based anode catalysts

In this paper,CeO_2 with a pore size of 2-4 nm was synthesized by hydrothermal method.The CeO_2 modified graphene-supported Pt catalyst was prepared by the microwave-assisted ethylene glycol reduction chloroplatinic acid method,and the effect of the addition of CeO_2 prepared by different hydrothermal reaction time on the catalytic performance of Pt-based catalysts was investigated.The microstructures of CeO_2 and catalysts were characterized by X-ray diffraction(XRD),X-ray photoelectron spectroscopy(XPS),specific surface area and pore size analyzer(BET),scanning electron microscopy(SEM) and electron spectroscopy(EDAX),transmission electron microscopy(TEM),and the catalysts electrochemical performance was tested by electrochemical workstation.The results show that the catalytic performance of the four catalysts with CeO_2 is better than that of the catalyst without CeO_2.Adding CeO_2 with a specific surface area of 120.15 m~2/g prepared by hydrothermal reaction time of 39 h to Pt/C synthesis catalyst,its electrocatalytic performance,stability and resistance to poisoning are the best.The electrochemical active surface area is 102.83 m~2/g,the peak current density of ethanol oxidation is 757.17 A/g and steady-state current density of 1100 s is 108.17 A/g which shows the lowest activation energy for ethanol oxidation reaction.When the cyclic voltammogram is scanned for 500 cycles,the oxidation peak current density retention rate is 87.74%.     

The control of paracetamol particle size and surface morphology through crystallisation in a spray dryer

The parameters governing the crystallisation of paracetamol using various conventional techniques has been extensively studied, however the factors influencing the drug crystallisation using spray drying is not as well understood. The aim of this work was to investigate the crystallisation of an active pharmaceutical ingredient through evaporative crystallisation using a spray dryer to study the physicochemical properties of the drug and to use semi-empirical equations to gain insight into the morphology and particle size of the dried powder. Paracetamol solutions were spray dried at various inlet temperatures ranging from 60 °C to 120 °C and also from a series of inlet feed solvent compositions ranging from 50/50% v/v ethanol/water to 100% ethanol and solid-state characterisation was done. The size and morphology of the dried materials were altered with a change in spray drying parameters, with an increase in inlet temperature leading to an increase in particle Sauter mean diameter (from 3.0 to 4.4 µm) and a decrease in the particle size with an increase in ethanol concentration in the feed (from 4.6 to 4.4 µm) as a result of changes in particle density and atomised droplet size. The morphology of the dried particles consisted of agglomerates of individual crystallites bound together into larger semi-spherical agglomerates with a higher tendency for particles having crystalline ridges to form at higher ethanol concentrations of the feed.     

New insight to the oxidation kinetics of silicon-containing steel at high temperature

This study investigated the oxidation kinetics of silicon-containing steel at 1150–1300 °C using a Simultaneous Thermal Analyzer under atmospheric conditions similar to that of an industry reheating furnace. There is a critical time point for the oxidation kinetics at an oxygen concentration of 4·0 vol.-%., following which the oxidation rate constant increases with the increasing oxidation temperature. The model coefficient A in the kinetic oxidation equation was found to be constant. However, before the critical time point, the oxidation rate constant remained unchanged; the model coefficient A decreased with the increasing temperature. Therefore, the kinetic model of silicon-containing steel for isothermal oxidation was observed to be a modified one on the basis of the experimental data. In addition, the critical time point was prolonged with the increasing isothermal oxidation temperature. Moreover, the oxidation activation energy of the tested silicon-containing steel was 366·16 kJ mol^?1.     

镓锗铜萃余液综合利用研究与应用

本文针对镓锗铜综合回收系统产出的萃余液,设计通过中和氧化除杂、锌粉置换除铜镉、有机试剂除钴镍、纯碱法生产碱式碳酸锌、高温煅烧生产活性氧化锌和一步法生产元明粉的生产工艺流程,有效的将镓锗铜萃余液分类分离富集,产出具有价值的富集渣和工业产品,进一步提升综合回收经济效益。     

Mean-stress and oxidation effects on fatigue behaviour of CM 247 DS LC alloy

During present investigations, an attempt was made to understand the effect of mean stress and oxidation on low cycle fatigue (LCF) behaviour of CM 247 DS LC alloy at T?=?850°C. A significant reduction in fatigue life was observed during LCF tests conducted at strain ratio (R) of 0 as compared to R?=??1. Reduction in fatigue life is attributed to the synergistic effect of mean stress, oxidation and the expanding precipitates within the grain boundaries which imparts high stresses at the grain boundary leading to the intergranular cracking. Additionally, to account the effect of mean stress on fatigue life of the alloy CM 247 DS LC empirical relations developed by Smith–Watson–Topper (SWT) and Morrow were used.     

Indoor boundary layer chemistry modeling

Ozone (O₃) chemistry is thought to dominate the oxidation of indoor surfaces. We consider the hypothesis that reactions taking place within indoor boundary layers result in greater than anticipated hydroxyl radical (OH) deposition rates. We develop models that account for boundary layer mass‐transfer phenomena, O₃‐terpene chemistry and OH formation, removal, and deposition; we solve these analytically and by applying numerical methods. For an O₃‐limonene system, we find that OH flux to a surface with an O₃ reaction probability of 10^?8 is 4.3 × 10^?5 molec/(cm² s) which is about 10 times greater than predicted by a traditional boundary layer theory. At very low air exchange rates the OH surface flux can be as much as 10% of that for O₃. This effect becomes less pronounced for more O₃‐reactive surfaces. Turbulence intensity does not strongly influence the OH concentration gradient except for surfaces with an O₃ reaction probability >10^?4. Although the O₃ flux dominates OH flux under most conditions, OH flux can be responsible for as much as 10% of total oxidant uptake to otherwise low‐reactivity surfaces. Further, OH chemistry differs from that for ozone; therefore, its deposition is important in understanding the chemical evolution of some indoor surfaces and surface films.     

Effects of hydroxyl radical induced oxidation on water holding capacity and protein structure of jumbo squid (Dosidicus gigas) mantle

Protein oxidation is considered as an important issue in food preservation process. In the present study, the potential influence of protein oxidation on water holding capacity and protein structure of jumbo squid (Dosidicus gigas) mantle was investigated. After the hydroxyl radical oxidation, it was found that the carbonyl, surface hydrophobicity and dityrosine content of myofibrillar protein significantly increased (P < 0.05), while the content of total sulphydryl decreased significantly (P < 0.01). Meanwhile, the fluorescence intensity of squid was weakened, and the maximum absorption peak of fluorescence red shift as the H₂O₂ concentration increased. The sodium dodecyl sulphate polyacrylamide gel electrophoresis (SDS-PAGE) showed that not only the protein cross-linking but also degradation could have occurred. The content of α-helix decreased, the content of β-sheet, β-turn and the unordered structures increased after oxidation. In addition, oxidation resulted in a decrease in water holding capacity. Taken together, oxidation resulted in the damage of the myofibrillar structure, the increase in muscle loss rate and the decrease in water holding capacity.     

Fenton 絮凝工艺去除废水中的有机物试验

为了研究废水中有机物的去除问题，针对某企业含有机物废水进行了对比试验，采用了Fenton 絮凝联合工艺去除废水中的COD（化学需氧量）和浊度，考察了初始pH值、H2O2投加量、H2O2与Fe2+投加物质的量比、反应时间、絮凝剂投加量以及絮凝剂投加时的pH值对COD以及浊度去除效果的影响。结果表明，采用最佳工艺参数组合后，浊度去除率和COD的去除率分别为99.32%和97.27%。